Everlast PowerTIG 255EXT AC/DC TIG Welder: 240 V

What it welds

The Everlast PowerTIG 255EXT AC/DC TIG Welder is an AC/DC TIG on 240-volt input; its listing doesn't state an output range, so check the rating plate.

The listing doesn't give a duty cycle with its amperage, which makes long beads hard to plan; the rating plate or manual should state it. Why it matters.

It's AC/DC, so it can weld aluminium as well as steel and stainless. Pulse: ac pulse.

It needs a 240-volt circuit; have a licensed electrician install the receptacle the manual specifies. 120 V vs 240 V.

Eye protection: OSHA's minimum is shade 8 for most of this machine's range (shade 10 for stick above 160 A). Full table.

Also on the listing: dimensions of 22 in (L) x 9 in (W) x 17 in (H) and a weight of 85 lb.

Is it the right machine for the job?

Buy it for

Aluminium and thin metal

Skip it for

What it does well, where it falls short

Does well

AC/DC for aluminium
Pulse: ac pulse

Falls short

Duty cycle not stated with amps
Needs a 240 V circuit
Output range not stated

Power and setup notes

Ratings are the maker's own, stated under the maker's conditions. Follow the manual, wear eye protection of at least OSHA's minimum shade, keep combustibles away, ventilate, and have a licensed electrician install new circuits.

Rated output and specs

Every figure below comes from the source shown in brackets. Where the maker doesn't state something, we say so instead of estimating.

Model number	PowerTIG 255EXT	Retailer
Power	ac/dc	Retailer
Wattage	255 W	Retailer
Model name	PT-255EXT	Retailer
Input power	240 V	Retailer
Dimensions (seller)	22"L x 9"W x 17"H	Retailer
Product weight	85 lb	Retailer
AC / DC	ac/dc	Retailer
Pulse	ac pulse	Retailer