MIG / gas · ESAB

ESAB ROGUE EM125 MIG Welder

MIG / gas, up to 125 A, 120 V

Updated October 2026

Quick verdict

A match for clean steel welds indoors.

Strength
Up to 125 A output.
Trade-off
Duty cycle not stated with amps.
Right buyer
Clean steel welds indoors.
Output range
125 amps
Input power
120v
Product weight
38.3 lb
Prices change often; the button shows today's price.

Each button opens this exact model. We may earn a commission on tracked links; it never changes what we publish. Disclosure

What it welds

The ESAB ROGUE EM125 MIG Welder is a MIG / gas with a maker-stated output of up to 125 amps on 120-volt input.

At its top output of 125 amps, Miller's 1-amp-per-thousandth rule points to about 1/8 in of steel per pass. Where the rule comes from.

The listing doesn't give a duty cycle with its amperage, which makes long beads hard to plan; the rating plate or manual should state it. Why it matters.

It runs solid wire under shielding gas for the cleanest wire-feed welds; most machines like it also run flux-core wire outdoors.

Household 120-volt power caps its output; check the circuit size the manual asks for. What input voltage changes.

Use a lens of at least OSHA's minimum shade for the current: shade 10 or darker for typical MIG work here. Shade chart.

Also on the listing: a weight of 38.3 lb.

Is it the right machine for the job?

Buy it for

  • Clean steel welds indoors
  • Sheet metal to about 1/8 in

Skip it for

  • Steel much past 1/8 in in one pass

What it does well, where it falls short

Does well

  • Up to 125 A output
  • Runs on household 120 V

Falls short

  • Duty cycle not stated with amps
  • 120 V caps output

Power and setup notes

  • Ratings are the maker's own, stated under the maker's conditions. Follow the manual, wear eye protection of at least OSHA's minimum shade, keep combustibles away, ventilate, and have a licensed electrician install new circuits.

Rated output and specs

Every figure below comes from the source shown in brackets. Where the maker doesn't state something, we say so instead of estimating.

Model numberROGUE EM125Retailer
Product weight38.3 lbRetailer
PoweracRetailer
Output range125 ampsRetailer
Input power120vRetailer

Machines to put next to it

Other mig and flux-core welders in the same amp range

Every mig and flux-core welders on one spec sheet · All ESAB machines listed

Final verdict

A match for clean steel welds indoors.

Where to buy

Our links open this exact model's product page. Prices and stock change; check what's included before you order.

Prices change often; the button shows today's price.

Each button opens this exact model. We may earn a commission on tracked links; it never changes what we publish. Disclosure

Questions buyers ask

How thick can the ESAB ROGUE EM125 MIG Welder weld?
By Miller's 1 A per 0.001 in rule its 125 A top output reaches about 1/8 in in one pass.
What is the ESAB ROGUE EM125 MIG Welder's duty cycle?
The listing doesn't state it with an amperage; check the rating plate or manual.
What power does the ESAB ROGUE EM125 MIG Welder need?
120 volts per the maker; the manual states the circuit and plug.